reference conditionの例文

• Good practice always incorporates the reference conditions of temperature and pressure.
• Other organizations have established a variety of alternative definitions for their standard reference conditions.
• Ecosystem definition determines the acceptable range of variability ( reference conditions ) and determines measurement variables.
• They use the FIT specification with 40 癈 and 0.5 U R as reference conditions.
• For example, ecologists and others have developed reference conditions for the ocean and for the Earth's crust.
• A companion grant from the same source focused on the identification of " reference conditions " in the Great Lakes.
• In some analyzers, the reliability of measurements is enhanced by calibrating the analyzer at the reference condition and a known span concentration.
• It also allows managers to recreate reference conditions and evaluate possible instream and watershed restoration measures or alterations ( such as dam removals or changes in water withdrawals ).
• This article presents methods for converting concentrations from ppmv to mg / m 3 ( and vice versa ) and for correcting the concentrations to the required reference conditions.
• Different conditions are also defined as reference depending on the application : for example, in soils, the reference condition is typically defined as pure water at the soil surface.
• The FDA stated " Your products are not generally recognized as safe and effective for the above referenced conditions . " In 2006 the FDA again warned Lapre about untruthful claims.
• The RBE is generally independent of LET for any LET less than 10 keV / 祄, so a low LET is normally chosen as the reference condition where RBE is set to unity.
• That is, " n " number of failed components per 10 5 hours, or in FIT the ten-thousand-fold value per 10 9 hours but for different reference conditions.
• Natural gas companies in Europe, Australia, and South America have adopted 15 癈 ( 59 癋 ) and 101.325 kPa ( 14.696 psi ) as their standard gas volume reference conditions.
• Optical Loss / Return Loss performance is checked using specific reference conditions, against a reference-standard single mode test lead, or using an " Encircled Flux Compliant " source for multi-mode testing.
• For tantalum capacitors, often the failure rate is specified at 85 癈 and rated voltage U R as reference conditions and expressed as per cent failed components per thousand hours ( n % / 1000 h ).
• These companies have received warning letters from the not generally recognized as safe and effective for the referenced conditions " and therefore must be treated as a " new drug " under Section 21 ( p ) of the Act.
• Additionally stated by the FDA, the goji juice was " not generally recognized as safe and effective for the referenced conditions " and therefore must be treated as a " new drug " under Section 21 ( p ) of the Act.
• It is good to know that for tantalum capacitors the failure rate is often specified in essence at 85 癈 and rated voltage U R as reference conditions and expressed as percent failed components per thousand hours ( n % / 1000 h ).
• It is good to know that for capacitors with solid electrolytes the failure rate is often expressed as per cent failed components per thousand hours ( n % / 1000 h ), and specified at reference conditions 85 癈 and rated voltage U R.